PE102-038 East Bay -2 Swap

The PE102-038 in East bay -2 position was measuring about 1/2 of expected counts. Flowmeter from the +4 position in East bay was swapped with -2 position until a replacement is available. 

10-4-2018 LEO Tipping bucket recalibration

We have recalibrated the LEO Novalynx tipping bucket. 10/4/2018 10:45pm data set onwards are using the new calibration values.

6/4/2019: The following shows the updated calibration coefficients used on the Novalynx.

Added UV sensor to LEO-OWS

A SU-100-SS-L-20 was added to the LEO-OWS.

*Found that 15 minute moving average for the HMP60, SQ110, LP02, was incorrect and has been fixed.
Unsure if 15 minute moving averaged data before 9/26/2018 12:15pm is correct.

Irrigation and seepage flowrate changed to incremental

The volume calculations for the irrigation (EX81) and seepage (Novalynx,PE102) have been update to show the change in volume between each logging time period (15 minutes) instead of cumulative volume.

Data from 9/6/2018 1:45pm onward reflect these changes.

Expect some data interruption on 9/5/2018 and 9/6/2018.

**Fixed irrigation incremental logging on 9/11/2018 11:00am. Please disregard data recorded from 9/11/2018 8am to 11am.

***EX81 incremental liters/sec can also be found on the Labview DSM.

Mini LEO Tipping bucket calibration change

Tipping bucket was calibration on 3/19/2018 by Antonio Meira.

This calibration was implemented on 6/27/2018 at ~6pm.

Mini LEO PE102 and Tipping bucket calculation change

The following sensors have changed from cumulative volume to volume per time interval.

6/19/2018 ~2pm: PE102

6/20/2018 ~11:45am: Tipping bucket

Mini LEO new enclosure 4/16/2018

We have upgraded the enclosure housing the sensor electronics to allow more room for further expansion of sensors on Mini LEO.

Periodic sensor outage due to this upgrade prior to 4/16/2018.

Decagon SDI12 sensor Firmware upgrade

We have upgraded the firmware on the Decagon 5TM (V4.00) and MPS2 (V3.86) to help prolong the life of the embedded sensors on the hillslopes.

The main features of the new firmware upgrades:

1. Only SDI12 addressed as Zero will go to awake state and send sensor read on during initial power on. All other non-zero addressed sensors will go to quiescent mode.
2. Help sensor be more robust to brownout conditions.

The following dates were the serials of events that occurred when the aforementioned sensors were powered off or on for the upgrades.

• 2/27/2018 - West hillslope powered off.
• 2/28/2018 - Center hillslope powered off.
• 3/1/2018 - West hillslope powered on.
• 3/2/2018 - Center hillslope powered on.
• 3/6/2018 - East hillslope powered off.
• 3/13/2018 - East hillslope powered on.

Tipping buckets LEO

Updated- 3/6/2019

West -1 NovaLynx tipping bucket was broken, Shell was replaced on 9/8/17. Calibration done and changed in DSM on server 9/11/17 12:45 to .033305 L/tip

East-2 NovaLynx tipping bucket was re-wired, possible bad connection creating spikes in data, will monitor over next rains and re-evaluate

1/15/19- Replaced reed switches on East Bay Nova Lynx +1 and +2 locations due to switch bouncing and noisy data. 

**The Nova Lynx proxy sensors have been rewired to eliminate the terminal block inside the tipping bucket enclosures. Rusting of the terminal blocks' terminals have been shorting the terminals causing noise. The voltage suppressor bi-directional diodes have been moved out of the rusting terminal blocks to the terminal blocks in the enclosure. Note that the terminal blocks were left inside the enclosures.

2/19/2019 - Rewired LEO East
3/6/2019 - Rewired LEO West. 3/13/2019 - LEO West leak tipping bucket

3/7/2019 - Rewired LEO Center bay

LEO_W_broken_sprinklerhead

Broken sprinkler head on multi 2 upon opening valve 8/1/17 7:00. Switched to Multi 1 circuit and will rain with Multi 1 today